Pbx install unistim nortel t7316e6/3/2023 ![]() From the Cisco doc, it may be 19.ĪIS State:Clear LOS State:Clear LOF State:Clear I am not sure if Nortel has set the 23 channel for signalling. Mgcp bind media source-interface Port-channel47 Mgcp bind control source-interface Port-channel47 Mgcp rtp unreachable timeout 1000 action notify Mgcp dtmf-relay voip codec all mode out-of-band Mgcp call-agent mcucm01 2427 service-type mgcp version 0.1 Service-policy output MetroQoS-Policy-Trust On my cisco side I have the following relevant config ![]() Number of L2 Discards = 0, L2 Session ID = 1 ![]() TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED Layer 3 output may not applyĭsl 0, interface ISDN Switchtype = primary-dms100 %Q.931 is backhauled to CCM MANAGER 0x0003 on DSL 0. The pins are correct as I had this up before I rebooted the cisco gateway. On the Cisco Gateway, ISDN status indicates Layer 1 is shutdown. My Nortel vendor mentions he has a D channel mismatch on his side. ![]() I have asked my Nortel PBX vendor to follow the Document 12986 ( Case Study: Nortel 61C PBX to Cisco IP Telephony Migration ) Starting Step 9. The telco carrier 2 PRI go into the Nortel, and then I have another PRI between the two PBXs. I am trying to integrate my Nortel Option 61C with my Cisco 2901 and CUCM.
0 Comments
Leave a Reply. |